1.3mm Oil restrictor adapter AN4
SPD Performance Parts
Reviews
Help others choose right. Be the first to write a review!
Write a review1.0mm Oil Restrictor Adapter AN4
This adapter allows you to easily create a custom oil restrictor by placing it between your AN adapter and AN fitting. Ideal for those looking to adjust oil flow without knowing the exact level of restriction from the start.
Note: Oil restrictors are only intended for ball-bearing turbochargers. They are generally not recommended for journal-bearing turbochargers (some exceptions may apply).
Instructions:
- Mount your AN4 oil inlet adapter on the turbo.
- Place the AN4 oil restrictor adapter onto the AN4 oil inlet adapter.
- Attach the AN4 oil line and tighten.
The adapter is made of aluminum and seals like a washer between the two cones.
Information
Generally, the oil pressure for a car engine usually ranges between 4 and 7 bar, depending on the engine's design, oil viscosity, and engine temperature.
A ball-bearing turbo should not exceed around 3 bar at maximum RPM.
Smaller hole restrictor = Less flow = Lower pressure
Larger hole restrictor = More flow = Higher pressure
Available versions:
1.0 mm
1.3 mm
1.6 mm
Set with all three variants
----------------
Guides & Info
Be first to write a review about this product!
Your review:
To send a review, you must be logged in.
Associated products
Suitable adapter
