AEM X-Series Wideband sensor and gauge
AEM
CAN, RS-232, 0-5V
Reviews
Help others choose right. Be the first to write a review!
Write a reviewAEM X-Series Wideband sensor and gauge
The AEM wideband lambda is the most popular meter on the market. Maybe because it is so easy to install and use? Quality and function are the two biggest advantages of this meter.
With the X-Series lambda, you easily read your values and log data through Canbus or analog at an even better price.
Characteristics:
- X-Digital Technology.
- Free air or resistance trim calibration modes (Ability to calibrate after aging).
- Fast response, 20ms ~.
- 2-1/16" / 52mm OD.
- Measured value from 8.0:1 to 20.0:1 AFR / 0.55 to 2.00 Lambda.
- Configurable 3- or 4-digit display mode.
- Lambda, AFR, O2 % display modes with reversible faceplate.
- Black frame/front plate included.
- Locking contacts.
- Supports vehicle/system voltages up to 16V.
- Supports Bosch LSU 4.9 sensor.
- 0-5V Analog output.
- AEMnet (CAN-bus) output.
- Serial RS-232 output.
Outputs:
Assembly diagram (NOTE for questions see installation guide at the bottom):
TIP!
If the display shows three lines, it means that the lambda probe presents values outside the display value. Then mount the lambda probe in the exhaust gas flow if this has not already been done. Step two is to replace and test with another lambda probe to get a value.
Information that applies to all lambda probes regardless of brand and especially wideband lambda:
# The sensor contains a "ceramic" part and is therefore sensitive to shocks and extreme fluctuations in temperature
# The sensor is not made to be used with leaded fuels. It works but will have a shorter lifespan
# Driving with a rich mixture shortens the life of the sensor (Lambda < 0.95)
# Exhaust gas temperatures above 850 degrees shorten the sensor's lifetime
# High engine oil consumption shortens the life of the sensor (1 liter / 16 miles)
# With the lambda probe installed in the exhaust system. -Do not start the engine without applying voltage to the meter and connecting the lambda probe to the meter
Included:
- X-SERIES UEGO Gauge (10-0400)
- X-SERIES AFR Gauge Assembly (35-0400)
- 4x Red insulated connections.
- Weld nut o2 SENSOR 1214 STEEL (35-4005)
- 2x Nut M4x0.7 (35-8618)
- Bracket for X-SERIES meter (35-8614)
- PWR/IO Cable for X-SERIES Meter (35-3430)
- Sensor cable for X-SERIES Meter LSU4.9 (35-3427)
- Rubber band for X-SERIES Meter (35-8617)
- Broadband lambda UEGO AEM/FAE (35-2404)
----------------
Guides & Info
Be first to write a review about this product!
Your review:
To send a review, you must be logged in.
Associated products
Tools
